The brand new JCM2000 Triple Super Lead [TSL] series takes the critically acclaimed circuitry of the JCM2000 Dual Super Lead [DSL] range and then goes one step further.

By giving you 3 independent channels (Clean, Crunch and Lead) and many innovative features, the all-valve TSL range puts an unheard of degree of control, flexibility and, most importantly, TONE at your finger tips. From crystal clean to the mightiest Marshall roar, the TSL does it all.

The JCM2000 Dual Super Lead has been hailed by players and critics alike as "the best Marshall ever made."

From sparkling clean to full-blown Marshall roar, this all-valve 100W head delivers it all. Each channel features its own volume, gain, and EQ. Master controls include tone shift for beefing up tone at low volumes, Accutronics spring reverb, effects loop mix control, speaker emulation DI circuit for silent recording, virtual power reduction that gives you a glorious, saturated power amp feel without cranking it up to 10.

Comes loaded with 4 ECC83 pre-amp valves, 4 EL34 power amp valves and also features two effects loops, loudspeaker outputs, a five-way LED foot controller, and more.

Features
All valve powered. [4x Svetlana EL34 power valves]

3 independent channels for Clean, Crunch, and Lead

Mid Boost Switch for tonal options on the Clean channel plus Tone Shift on the Crunch and Lead channels

Unique Marshall Deep Switch on the Clean and Crunch/Lead channels adds extra low end resonance when selected

Separate Reverb for Clean and Crunch/Lead channels

Virtual Power Reduction [VPR] gives the extra saturation of a lower powered valve amp being driven hard

Power Amp Mute switch for silent recording

Separate FX Loops with front panel Mix controls and level selection for the Clean and Crunch/Lead channels

D.I. XLR Output with acclaimed Marshall Speaker Emulation

5-way foot controller for switching channels, Reverb and FX Loop on/off

Technical Info
Output power: (typical) 120 watts at 5% THD into 4/8/16 ohms

Mains input: 117V ~ 60Hz or 230V ~ 50Hz (standard) - others to special order (To alter amplifier for different mains voltage specification to that delivered (i.e. 120V to 230V etc), please contact your country's Marshall distributor or main service center.)

Mains power input: 375 watts.

Mains fuse: T4A - 117V or T2A - 230V

HT fuse: T1A

Valve (Tube) complement: 4 x ECC83 (12AX7) - preamp and phase splitter (inverter). 4 x EL34 - output. Marshall - Svetlana fitted as standard